|
NICKEL 500/ Alloy K500 |
SHEET | PLATE | COIL/FOIL
| ROD | PRODUCTS
|
Age-hardenable version of
alloy 400 for increased strength and hardness.
Used on:
Pumps, shafts, doctors
blades and scrapers, oil-well drill collars and instruments,
electronic components, springs, valve trim, fasteners |
NOMINAL DATA SHEET
|
|
| NI - 66.5 |
Oil well drill collars |
| C - .13 |
Doctor blades |
| MN - .75 |
Pump shafts and impellers |
| FE - 1.0 |
Springs |
| SI - .50 |
Electronic components |
| CU - 29.5 |
Gasoline and Fresh Water Tanks |
| AL - 2.73 |
|
| TI - .63 |
|
| |
| NOMINAL
MECHANICAL PROPERTIES (ANNEALED CONDITION) |
| Ultimate Tensile Strength, psi - 90,000
to 110,000 |
| 0.2% Offset Yield Strength,
psi - 40,000 to 60,000 |
| Elongation in 2 inches
percent - 45 to 25 |
| Hardness, Rockwell - 140 to
185 |
| |
| NOMINAL
MECHANICAL PROPERTIES (ANNEALED and AGED) |
| Ultimate Tensile Strength, psi -
130,000 to 165,000 |
| 0.2% Offset Yield Strength,
psi - 85,000 to 120,000 |
| Elongation in 2 inches
percent - 35 to 20 |
| Hardness (Brinell) - 250 to
315 |
| |
| SHEET |
PLATE |
COIL/FOIL |
ROD |
.050
.062
.078
.109
.125
.140 |
.250
.375
.500
.750
1.00 |
.003
.004
.005
.010
.015
.020
.030
.040
.050
.062 |
.125
.250
.312
.437
.500
.625
.750
.875
1.00
1.25
1.50
1.75
2.00
2.25
2.50
3.00
3.50
4.00 |
Top of Page
Disclaimer
Every effort is made to ensure that
technical specifications are accurate. However, technical specifications
included herein should be used as a guideline only. All specifications are
subject to change without notice.
|
